The course is CAD ( Computer Aided Design) which uses the assistance of computers to design and check the design is ready and good to be constructed. The Solar Oven was the project that we worked on during the whole semester. The Project goals where to designs and build a solar oven using the CNC milling machine. The most difficult part about it was to learn how to use mastercam since in mastercam if we didn’t put the right measurement we had to start all over again. The Easiest part was when I had to test it out and see if it works. Over all the Solar Oven design challenge was difficult to accomplish but after using the CNC milling machine the rest was easy. The assembly part was the funnest because we painted and foil the box. What I learned from this project is to make sure that the panels were big enough and be able to bend into a certain angle in order for the sun ray to hit and warm up the box.